Archive for February 25th, 2010

How To Fix Compression Or Stem-Type Faucet ?

Thursday, February 25th, 2010

Compression or stem type faucet – This is a two-handle faucet design. With a single faucet, you can enjoy both hot and cold water as per the requirement. You can tell a stem faucet by the way it feels when you turn it off. You should feel a rubber washer being squeezed inside the faucet.

The working of the faucet is simple. At the bottom of the stem it consists of a rubber seal. It presses against the valve seat to block the water flow. Turning the handle the other way releases the seal against the seat and the water flows. However, compression faucets are much more prone to leaks due to the twisting motion which in time wears out the rubber seal at the bottom of the stem.

One can easily repair the leaks in the faucet. The write up provides you the steps to carry out project more effectively. Shut off the water to the faucet. Take apart your sink. You will need a screwdriver and pliers for this task. Take off the decorative covers on both faucets.

Caring For Your Plumbing Fixtures

Thursday, February 25th, 2010

No part of the house is more important than plumbing. Nothing in the house is used more often. A smoothly functioning plumbing system is a pin to health and adds to the convenience of modern living. However most of the homeowners neglect maintaining this very need of the house. Long avoiding the fault may hurt the integrity of your plumbing setup to a large extent.

You must have heard the saying “Flaws appear minor at first sight turn more daunting if left unnoticed for a long time”. Same is the case with the leaks, holes and seepage in the plumbing. Such irregularities allow the water to creep into the internal structure of your walls and ceilings. A neglected plumbing will collect late fees from your pocket whereas regular timely checkup will avoid worries and extra expenses.

To start with inspect the leaky accessories and devices such as taps, faucets, showers, pipes etc in your home. By turning them on and off repeatedly, you can determine whether they are working normally or have some abnormality. The detection of leaks from the concerned plumbing segment would point towards any plumbing fault. So, repair them at the earliest